ProLights CYBER192 - 5 Chase; Create a Scene; Copy Bank into Chase; Adding a Step to a Chase

CYBER 192
12
- 5 - CHASE
A chase is created by using previously created scenes. Scenes become steps in a chase and can be ar-
ranged in any order you choose. It is highly recommended that prior to programming chases for the rst
time; you delete all chases from memory. See “Delete All Chases” for instructions.
5.1 CREATE A CHASE
1. Press and hold the [PROGRAM] button for 3 seconds.
2. Press the [CHASES] (1~6) button you wish to program.
3. Change BANK if necessary to locate a scene.
4. Select the SCENE to insert.
5. Tap the [MIDI/ADD] button to store. All LED’s will ash 3 times.
6. Repeat steps 3 ~ 5 to add additional steps in the chase. Up to 240 steps can be recorded.
7. Press and hold the [PROGRAM] button for 3 seconds to save the chase.
NOTE - A Chase can contain 240 scenes as steps. The term steps and scenes are used interchangeably.
5.2 COPY BANK INTO CHASE
1. Press and hold the [PROGRAM] button for 3 seconds to enter programming mode.
2. Select the BANK to be copied using the [BANK UP]/ [BANK DOWN] buttons.
3. Press [MUSIC/BANK COPY] and [MIDI/ADD] buttons at the same time to copy.
4. Press and hold the [PROGRAM] button for 3 seconds to exit programming mode.
5.3 ADDING A STEP TO A CHASE
1. Press and hold the [PROGRAM] button for 3 seconds to enter programming mode.
2. Press the desired CHASE (1~6) button.
3. Press the TAPSYNC/Display and the display will display the scene and bank number. This displays the
scene you will be adding (STEP LED must be on),
4. Use the [BANK UP]/ [BANK DOWN] buttons to scroll through the chase and arrive at the step number for
which you would like to add or append a scene/step to.
5. Press [MIDI/ADD] button and one step number will be added to the previously displayed step number.
6. Press the SCENE button that corresponds to the scene to be copied.
7. Press [MIDI/ADD] button again to add the new step.
8. Press and hold the [PROGRAM] button for 3 seconds to exit programming mode.
5.4 DELETE A SCENE/STEP IN A CHASE
1. Press and hold the [PROGRAM] button for 3 seconds to enter programming mode.
2. Press the desired CHASE (1~6) button that contains the scene to be deleted.
3. Press the TAPSYNC/DISPLAY button to switch the LED display to steps.
4. Select the scene/step to be deleted using the [BANK UP]/ [BANK DOWN] buttons.
5. Press AUTO/DEL button to delete the step/scene.
6. Press and hold [PROGRAM] button for 3 seconds to exit.
5.5 DELETE A CHASE
1. Press and hold the [PROGRAM] button for 3 seconds to enter programming mode.