What to do if ProLights EVO64CYC does not power up?
If your ProLights Lighting Equipment isn't powering up, first, ensure the power outlet is working. Next, inspect the power cord for any damage or looseness. If the issue persists, the internal power supply might be faulty and need replacement.
How to fix ProLights EVO64CYC Lighting Equipment when it does not light up?
If your ProLights Lighting Equipment isn't lighting up, start by checking the power supply voltage. Then, make sure the dimmer and color faders aren't set to 0; increase their values. If the issue continues, a faulty LED or LED board might be the cause, requiring replacement.
Why ProLights EVO64CYC does not respond to DMX?
If your ProLights Lighting Equipment isn't responding to DMX, verify the DMX addressing on both the control panel and the unit. Also, check the DMX cables for any damage. If you suspect bouncing signals, install a terminator as suggested.
How to improve low light intensity on ProLights Lighting Equipment?
If you're experiencing low light intensity with your ProLights Lighting Equipment, the lens assembly may be dirty; clean the fixture regularly. Alternatively, the lens assembly might be misaligned; ensure it's installed properly.
General| LEDs life | 50, 000 hours |
|---|---|
| Input Voltage | 100-240V AC, 50/60 Hz |
| PowerCON in/out | Yes |
| IP Rating | IP20 |
| Type | LED Wash |
| Optical system | High-efficiency optics |
| Electronic Dimmer | 0~100% linear dimmer |
| Strobe | 1-25Hz |
| Control Protocol | DMX, RDM |
| Operating mode | DMX, Master/Slave |
| Data connection | XLR 3-pin in/out |
To Next Page
