ProLights EVO64CYC - Operation in Automatic Mode; Master;Slave Mode; Linking; DMX Configuration

EVO64CYC
10
3.4 OPERATION IN AUTOMATIC MODE
If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched o:
• Press the button MENU so many times until the display shows [AUTO], then press the button ENTER.
• Press the button UP/DOWN to switch between the programs (AT. 01 - AT.10 o PR.01 - PR.10). The unit will
operate in automatic mode.
NOTE - Programs AT.01 - AT.10 are fully pre-programmed and will not be altered by changes in EDIT mode.
Programs PR.01 - PR.10 are fully pre-programmed and can be edited in EDIT mode.
In automatic mode the unit will be set as Master.
3.5 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the rst unit in line; other units will work as slave with the same eect.
• Press the button MENU so many times until the display shows [RUN], and press the button ENTER to
conrm.
• Press UP/DOWN to set the unit as [SLAV].
• Select the desired program (see section 3.4).
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last xture (see page 12).
3.6 LINKING
Several units may be interconnected in order to control all further slave units to the same eect of the
master unit.
1. Connect the DMX OUT of the master unit via 3 -pole XLR cable to the DMX IN of the rst slave unit.
2. Connect the DMX OUT of the rst slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
3.7 DMX CONFIGURATION
EVO64CYC is equipped with 11 DMX conguration.
• Press the button MENU so many times until shows [PERS], and press the button ENTER to conrm.
• Select the desired DMX conguration [TOUR - TR16 - ARC.1 - AR1.d - ARC.2 - ARC3 - AR3.D - AR3.S - HSV - PIX1 - PIX3]
through the buttons UP/DOWN.
The tables on page 13 indicate the operating mode and DMX value. The EVO64CYC is equipped with 3 - 5
pole XLR connections.
3.8 DMX MODE
• Press the button MENU so many times until the display shows [RUN], and press the button ENTER to
conrm.
• Press the buttons UP and DOWN to select [DMX] mode.
• Then enter the [dMX] mode to set the ID address.
• Press the buttons UP and DOWN to select the desired value [001-512].
• After the setting value is automatically saved.
NOTE - When xtures are under Auto program operation, the [RUN] mode does no works.