ProLights EVO64CYC - Activate the Password

19
EVO64CYC
WHITE BALANCE
Enter the [CAL2] mode to adjust the RGB parameter to make dierent whites.
• Press the button MENU so many times until show [CAL2] and press the button ENTER to conrm.
• Select red, green blue or white (RED - GREEN -BLUE), through the button UP/DOWN. Press the but-
ton ENTER to conrm.
• Set the value 000 - 255, through the button UP/DOWN.
• When the new setting is activated, the DMX controller choose RGB=255, 255, 255 the write color will
be made by actual RGB values on the [CAL2].
3.17 ACTIVATE THE PASSWORD
Enter the KEY mode to select whether the access password is on or o.
• Press the button MENU so many times until show [KEY] and press the button ENTER to conrm.
• Select [ON] or [OFF].
When the xture is set as pass [ON], after 30 seconds or turn on the xture next time, the xture will need
an access password to enter the display menu control.
NOTE - The factory access password is UP + DOWN + UP + DOWN. Press ENTER to conrm the access.