ProLights MOBY40 - Calibration Function; Operation with Wireless DMX

MOBY40
22
3.17 CALIBRATION FUNCTION
Press the button MENU to enter the password conrmation, to enter the correct password
UP+DOWN+UP+DOWN button, press the MENU in the correct password will enter show submenu.
WHITE SETTING
Enter the [CAL] mode to select white color of dierent color temperature;
• Press the button MENU then press the button UP/DOWN so many times until show [CAL1]. Press the
button ENTER to conrm.
• There are 11 pre-programmed white colors (WHITE01 - WHITE11) can be edited by using red, green,
blue, and white (Red - Green - Blue - Amber).
• Set the value (000 - 255), through the buttons UP and DOWN.
WHITE BALANCE
Enter the [CAL2] mode to adjust the RGB parameter to make dierent whites.
• Press the button MENU so many times until show [CAL2] and press the button ENTER to conrm.
• Select red, green blue or white (RED - GREEN -BLUE), through the button UP/DOWN. Press the but-
ton ENTER to conrm.
• Set the value 000 - 255, through the button UP/DOWN.
• When the new setting is activated, the DMX controller choose RGB=255, 255, 255 the write color will
be made by actual RGB values on the [CAL2].
3.18 OPERATION WITH WIRELESS DMX
• Connect to DMX Controller, the transmitter will transmit signal to the other connected xtures (g.15).
NOTE - Be sure the MOBY40 are Max 300 meters around the transmitter.
• Power on all units.
• Enter menu mode of the unit, set wireless control to be available.
- Press the button MENU then press the button UP/DOWN so many times until show [RUN]. Press the
button ENTER to conrm.
- Press the buttons UP and DOWN to select [DMX] mode.
• Then enter the [WDMX] mode to change WDMX settings.
- Enter the [ACTI] menu to turn On/O WDMX functionality.
- Enter the [REST] menu to reset the WDMX pairing.
• Once a lighting xture has been paired with a WDMX transmitter, the green signal indicator will display.
Once a lighting xture has been paired with a WDMX transmitter, the lighting xture cannot be paired
with another WDMX transmitter. If a lighting xture requires pairing with a new WDMX transmitter, the
steps must ben repeated.