Usingtheremotecontrol- Remotecontrolinstructions
Inserting the batteries into the remote control
1. Open the cover of battery cabin on the back of the remote control.
2. Insert two AAA 1.5V batteries, ensuring the correct polarity (+/-).
3. Close the cover.
• If the remote control is not working, see the checkpoints below.
• Are the polarities of the batteries (+, -) correct?
• Are the batteries worn out?
• Is there an AC power failure?
• Is the power cable plugged in?
• Is any special fluorescent or neon sign board turned on?
Remote Control Reception Angle
Use the Remote control within a range of 7~10m and at an angle of 30 ° to either side of the receiver.
CAUTION
Used batteries should be recycled.
Kept out of children's reach.
Do NOT use new and old batteries together.
Change both batteries at the same time.
When not using the remote control over a long time, remove the batteries from the unit.
]3
To Next Page
Loading...
