37
The screen shot above will be shown once you select a VC to configure. Fill up IP address, subnet mask,
gateway, encapsulation type, and VPI/VCI information. Then, setup QoS class (UBR, CBR, VBR-RT and
VBR-NRT), QoS PCR (Peak Cell Rate), and QoS SCR (Substained Cell Rate) information.
For Bridge mode, “Protocol” provides two options, “Disable” or “Ethernet over ATM”.
However, for Router mode, there are four options in “Protocol” menu, “Disable”, “IPoA”, “PPPoA” or “PPPoE”.
To Next Page
Loading...
