General Components
On/Off Switch
When you place the switch in the “off” position the motor will
immediately stop operating. During maintenance and
adjustment place the switch in the ‘off’ position in order to
prevent the machine from starting unexpectedly.
Switch to the left position is “on”
Switch the right position is “off”
Hopper Air Inlet Valve / Tube
This controls the proportion of air in the mix as it feeds
through to fill the freezing cylinder from the hopper. It is put
in place only once the freezing cylinder has been primed/filled
with product.
Dispensing
Door
This is used to dispense and shape the mix from the
freezing cylinder.
Beater
Bar
The bar(s) rotates within the machine during FREEZE and
WASH mode. When dispensing product the beater bar rotates
pushing the product through the dispensing door.
To Next Page
Loading...