P. 10 User Guide CT-3400 TW
Turbo Mode
When programmed (at the time of installation), this option allows turbochargers to idle down after
the user leaves the vehicle the engine will keep running for 60 sec. and shut down.
Proceed as follows to activate Turbo Mode:
1. With the Engine already running press
LOCK on the transmitter until the parking lights come on.
2. Remove the key: the engine will go on running.
3. Exit the vehicle and close the door.
4. Press the
TRUNK button to lock the doors and shut down the engine after 60 sec. of running in
Turbo Mode.
Home Valet™ Mode
This safety feature will remotely place the vehicle into a No-remote-start Mode: if the vehicle is
parked indoors there is no danger it will start accidentally by remote control or external trigger.
To e n t e r Home Valet™ Mode:
• Press LOCK or UNLOCK on the transmitter.
• Within 5 seconds, press LOCK + START: the Transmitter will display the icon
and you will hear a beep.
To e x i t Home Valet™ Mode:
• Turn the ignition key to the IGNITION ON (RUN) position.
Note: Once Home Valet™ is activated, the vehicle will not start by remote control or external
trigger until the ignition key is turned to the IGNITION ON (RUN) position.
Remote Valet Mode
This feature will allow you to remotely put your system into Valet Mode by using the transmitter
instead of the valet button as above.
Getting i n t o R e m o t e Valet Mode
• Hold the UNLOCK and START/STOP buttons simultaneously for 3 seconds.
• The Parking Lights will flash 3 times.
The transmitter will BEEP once and will display the icon; the LED will remain on solid.
Getting o u t of Remote Valet Mode
• Hold the UNLOCK and START/STOP buttons simultaneously for 3 seconds.
• The parking lights will flash 2 times.
The transmitter will BEEP once and the icon will disappear; the LED will turn off.
Note:
With the remote valet mode activated, the
remote starter function will be disabled.
Valet Mode
Ignition Valet
The system can be placed in Valet Mode to disable the remote starting capabilities. If the vehicle
needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine from being
accidentally started by remote control.
To ENTER Ignition Valet Mode
1. With the key in the Ignition switch, turn the key to the ON (RUN/IGNITION) and then OFF
positions 5 times within 10 seconds.
To Next Page
Loading...
