ProStart CT-3400 TW - System Diagnostics; Parking Lights Flash Codes

CT-3400 TW User Guide P. 15
Diagnostics
Parking Lights Flash Rate (Normal Operation)
Flashes Description
1
• Doors locked, starter kill armed.
• End of run time.
•
button pressed
• Start signal received by the module.
• Cold weather mode cancelled.
• Enabling LED
2
• Doors unlocked, starter kill disarmed.
• Run time cancelled.
• Remote start attempt cancelled by remote.
• Exiting remote valet.
• Exiting ignition valet.
3
• Entering cold weather mode.
• Entering extended run time.
• Entering remote valet
• Entering ignition valet
• Disabling LED
4
• +12 V where detected on the brake line and cranking was cancelled.
• Entering tach programming mode
5
• New transmitter programmed.
• Tach programmed.
6
• A remote start was attempted while a tach or a vacuum signal was detected before
cranking.
8 • Unit reset: occurs when the unit is reset to the factory defaults.
10 • The hood switch line went to ground during cranking or run time.
1 – pause – 2 • There was an attempt to start the vehicle while the module was in valet mode.
ON solid • Cold weather mode: the brake pedal is being held down.
2 – pause – 2
• There was an attempt to start the vehicle while the module was in home valet
mode.
ON 2 sec.
• The hood is up and the hood switch line went to ground. This is step one of the
programming centre procedure.
ON 3 sec.
• First press of the
button under safe start.
ON 4 sec. • Locking or unlocking a door (with door pulses configured to 4 sec.)
ON 25 sec.
• The hood pin-switch has been pressed twice: the unit went into step 1 of the
programming centre procedure, and no transmitter activity was detected for 20
seconds.
• Or the unit went into step 1 of the transmitter programming procedure and no
activity was detected for a few seconds. The unit has exited the transmitter
programming procedure.
Irregular
• If the unit gives irregular signals (1 to 10 flashes followed by a pause, followed by
further flashes), the system is playing back start failure codes. This occurs when the
hood pin-switch is pressed three times
Constant flashes
up to 25 sec.
• Panic mode is triggered.