Protherm PTCP - Programming and Scheduling Features

INSSTCP0408
From this mode, the screen displays the temperature, the set
point, the hour, the day of the week and the current programmed
periodnumber(1to4;asapplicable).
Programming Procedure of the Automatic Mode
After programming a day of the week, you can copy this setting;
see “Copy of the Programming”.
1. To access the Programming mode, press down the day of the
week button that you want to program (Mon to Sun). Once you
release the button, the selected day of the week is displayed,
the SET icon blinks and the period number 1 blinks too.
2. Select the period number (1 to 4) that you want to program us-
ing the + or - button. For each period, the hour and the set point
are displayed. The hour displays --:-- and the set point displays
-- if there is no programming for the period. You must confirm
the period by pressing down the Mode button.
3.Thetwoguresrepresentingthehourblinktoindicatethatyou
canadjustthem(from00to23)usingthe+or–button.Youmust
confirm the adjustment by pressing down the Mode button.
4. After confirmation, the figures representing the minutes (the
last 2 figures) blink. You can adjust and confirm them in the
mannerdescribedinpoint3.Notethattheminutescanonly
beadjustedbyincrementsof15minutes.
5.The period set point blinks and you can adjust it using the
+ or - button. You must confirm the adjustment by pressing
down the Mode button.
6. After set point confirmation, the programming is completed.
The following period number blinks. For example, if the previ-
ously programmed period was 1, period 2 blinks. It is then
possible to continue the programming of this period by press-
ing down the Mode button. You can also select another period
usingthe+or–button.
7.Attheendofperiod4programming,youautomaticallyexitthe
Programming mode.