Protherm PTCP - Erasing of the Programming; Preprogrammed Mode

INSSTCP0408
Erasing of the Programming
You must proceed as follows to erase a programming period.
1. Access the Programming mode as described previously by
pressing down the button corresponding to the day to modify.
Select the period to erase using the + or - button.
2. You do not have to press down the Mode button to confirm the
selection. However, doing so will not impact on the erasing.
3.Simultaneouslypressdownthe+and–buttonstoerasethe
period programming. The hour displays --:-- and the set point
displays -- to indicate that the programming is erased.
4. The erased period number blinks and you can select another
period to be erased or exit the Programming mode following
oneofthe3methodsdescribedabove.
Preprogrammed Mode
The Preprogrammed mode allows an automatic programming of
thethermostat.252preprogrammingshavebeendenedforAmbi-
entmodeand252,forFloormode(A0toZ1and0to9;seeappen-
dix 1 to consult the corresponding tables). This mode gives you the
possibility to quickly program the thermostat using preprogram-
mings commonly used without having to do it manually.
As from the Automatic mode, it is possible, at any time, to manu-
ally adjust the set point. This set point will be effective until the
next set point change anticipated by the preprogramming. Note
that if the set point is lowered to OF, the programming will not
be effective.
From this mode, the screen displays the Ambient/Floor tem-
perature, the Ambient/Floor set point, the hour, the day of the
week and the letter and current number of the preprogramming
(A0toZ1and0to9;alpha-numericsegmentdisplayedonthe
right-handsideofthehour;seeappendix1).