Protherm PTCP - Choice of the Preprogramming

INSSTCP0408
Choice of the Preprogramming
You can only access the Preprogramming mode when the ther-
mostat is out of any programming or adjustment function. Make
sure to choose the preprogrammings corresponding to the right
mode (Ambient /Floor, according to the attached tables).
You must proceed as follows to access the Preprogramming
mode:
1. Press down the Pre Prog button.
2. The Pre Prog icon and saved selected preprogramming are
displayed. This preprogramming can range between 0 and
Z1.
3.FromthePreProgmode,youcanchoosetherst10preprogram-
mings by pressing and releasing the Pre Prog button. Each time you
pressdownthebutton,thepreprogrammingswitches(from0to9).
4. To choose advanced preprogrammings, (see appendix 1), press
downthePreProgbuttonduring5seconds.Theletterindicator
blinks and you can adjust it by pressing down the + or - but-
ton. Once the letter is chosen, you must validate your choice by
pressing down the Mode button. The letter ceases to blink and
the figure starts to blink. The choice of the figure is made in the
same way as that of the letter (using the + or - button). Once
the figure is selected, you must validate your choice by pressing
down the Mode button.
N.B. If you do not press down any button for more than one minute
or press the Exit button, the thermostat exits the adjustment
function and saves the current choice. Then, the icons cease
to blink and the letter and the figure corresponding to the
selected preprogramming blink alternately until you select
another preprogramming. If the Pre Prog mode is activated
and you successively press down the Pre Prog button, the
preprogramming comes back to 0 and increases normally,
as described above.