Protherm PTCP - Display in Degrees Celsius;Fahrenheit

INSSTCP0408
4. The two figures indicating the minutes blink. You must adjust
them using the + or - button and confirm your choice by press-
ing down the Mode or Day/Hr button. The adjustment is then
completed and the thermostat returns to the previous mode.
N.B. At any time, you can exit the adjustment mode of the day
and the hour by pressing down the Exit button or by not
pressing any button during 1 minute.
In case of a power failure, the thermostat is self-sufficient for 2
hours. If the failure lasts less than 2 hours, the thermostat saves
the adjustment of the hour and the day of the week. When the
power is restored after an extensive failure (more than 2 hours),
the hour and the day of the week are recovered, but you must
update them.
Display in Degrees Celsius/Fahrenheit
The thermostat can display the ambient temperature and the set
point in degrees Celsius (standard factory setting) or Fahrenheit.
Adjustment procedure for degrees Celsius/Fahrenheit display.
1. To switch from the degrees Celsius to the degrees Fahrenheit,
and conversely, simultaneously press down the + and - but-
tonsformorethan3secondsuntiltheSETiconblinks.
2. Press down the + button to switch from the degrees Celsius to
the degrees Fahrenheit, and conversely. The degree Celsius or
Fahrenheit symbol is displayed.
3.Whentheadjustmentiscompleted,pressdowntheExitbut-
tonordonotpressdownanybuttonduring5secondstoexit
the adjustment function.
N.B. This adjustment can be done from any of the three principal
modes.