Protherm PTCP - Copy of the Programming

INSSTCP0408
Copy of the Programming
You can apply the programming of one day of the week to other
days by copying the programming day by day or in block.
To copy the programming day by day, you must:
1. Press down the source day button (day to be copied).
2. Hold down this button and press down the destination days one
by one. The screen displays the selected days. If an error occurs
when you are choosing a day, press down the erroneous day
again to cancel the selection.
3.Afterallselectionsarecompleted,releasethesourcedaybut-
ton. The selected days have the same programming as the
source day.
To copy the programming in block, you must:
1. Press down the source day button, hold it and press down the
last day of the block you want to copy.
2.Holddown these twobuttonsfor3seconds.Afterthistime,
the days of the block are displayed indicating that the copy in
block is activated.
3.Releasethebuttons.Thedaysoftheblockarenotdisplayed
anymore and the current day is displayed.
N.B. The block order is always increasing. For example, if the
source day is Thursday and the destination day is Monday,
the copy will only include Friday, Saturday, Sunday and Mon-
day.