Provision ISR IP Series - Server; Nat

Step 2: Set SMTP Server and port.
SMTP Server/Port: The name and port number of SMTP server. You can set up SSL check (such as Gmail)
according to actual needs.
Step 3: Set sender’s address and password.
Step 4: Set receiver’s email address and click “Test” button to test the validity of the mailbox.
5.6.4 Server
This function is mainly used for connecting ECMS/NVMS. The setting steps are as follows:
Step 1: In the server interface, select “Enable” as shown in the Fig 5-25.
Step 2: Check the IP address and port of the transfer media server in the ECMS/NVMS. The default server
port for auto report is 2009. If it is modified, please enter into the transfer media interface to check.
Step 3: Enable the auto report in the ECMS/NVMS when adding a new device. Then self-define device ID
and input the remaining information of the device in the ECMS/NVMS.
Step 4: Input the above-mentioned server IP, server port and device ID in the server interface. Then click
“Apply” button to save the setting. Now, the ECMS/NVMS system will automatically connect this device.
Fig 5-25 Network Configuration-Server
5.6.5 NAT
① Go to Main MenuSetup NetworkNAT interface. Refer to Fig 5-26.
② Enable NAT and input the NAT Server (The default NAT Server is
www.provisionisr-nat.com).
③ Click “Apply” to save the settings.
Fig 5-26 Network Configuration-NAT