Version 1.0
11
Safety Precautions
11
Check the damaged parts:
• Before using, it is necessary to check the hoist completely. An authorized Prowinch service center needs to
repair or replace any part that is damaged.
Repair the Hoist:
• To repair, use only original Prowinch spare parts, otherwise you can put the user in danger. The use of any
other spare will cause the warranty to expire or be voided. Only use accessories manufactured for this hoist.
• If the cable is worn out, it must be replaced, provided only by the original cable and produced by us in an
authorized workshop.
Wind the cable:
• Before starting work, carefully check that the steel cable is correctly wound on the roll, with a pitch
corresponding to the diameter of the cable.
• You must wear leather gloves to wind the cable. To wind correctly it is necessary to keep a small load on
the cable. While the operator rolls the cable, another person should guide it in its correct location. Start
from far and as center as possible. Walk with the load on the cable while the hoist rolls up.
• Keep at least three turns of cable.
• Do not allow the cable to fall and approach the hoist.
• Turn o the hoist and repeat the process until only 3 feet of cable remains.
• Disconnect the remote control and / or cut o the power supply.
• Never wind the entire cable, always leave 25 cm to avoid any danger.
Improperly connecting the grounding wire can result in the risk of electric shock.
Check with a qualied electrician if you are in doubt as to whether the outlet is
properly grounded. Do not modify the power cord plug provided with the tool.
Never remove the grounding prong from the plug. Do not use the tool if the
power cord or plug is damaged. If damaged, have it repaired by a service facility
before use. If the plug will not t the outlet, have a proper outlet installed by a
qualied electrician.
To Next Page
Loading...
