EasyManuals Logo

Proxim Tsunami 8000 series User Manual

Proxim Tsunami 8000 series
170 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #49 background imageLoading...
Page #49 background image
Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 49
Active Network Mode A change in the network mode (either Bridge or Routing mode) is applied on the device
only when the device is rebooted.
So, when the network mode is changed and the device is not rebooted, this parameter
displays the current operating network mode of the device.
Frequency Filter Lower
Edge, and
Frequency Filter Upper
Edge
These parameters enables to define the lower and upper frequency band edges, which
helps to limit the available frequency band, for a given frequency domain, to a smaller
band. By limiting the frequency band, the time taken by a device to scan and connect to
any other device in the network is reduced.
Enter frequencies ranging from 0 to 10000 MHz. By default the lower frequency is set to 0
MHz and higher frequency is set to 10000 MHz.
Parameter Description

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Proxim Tsunami 8000 series and is the answer not in the manual?

Proxim Tsunami 8000 series Specifications

General IconGeneral
BrandProxim
ModelTsunami 8000 series
CategoryNetwork Router
LanguageEnglish

Related product manuals