Proxim Tsunami 8000 series User Manual

Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 66
:
·
To enable Dynamic NAT, set the NAT Status to Enable. To enable Static NAT, set the NAT Status to Enable and
the Port Forwarding Status to Enable.
·
NAT uses the IP address of the wireless interface as the Public IP address.
To add entries in the NAT Port Bind Table, navigate to ADVANCED CONFIGURATION > Network > NAT > Static Port
Bind. The NAT Port Bind Table screen appears. Click Add in the NAT Port Bind Table screen. The following NAT Port Bind
Table Add Row appears:
Figure 5-14 NAT Port Bind Table Add Row
Given below is the table which explains the NAT Port Bind Table entries and the method to configure the configurable
parameter(s):
After configuring the required parameters, click ADD and then COMMIT.
Parameter Description
Local Address Enter the local IP Address of the host on the Ethernet (private) side of the SU/End Point B.
Port Type Select the Port Type as: TCP, UDP, or Both.
Start and End Port
Number
Represents the start and end port for transferring the data from public to private host.
: Care should be taken to avoid overlap of Dynamic Port range and Static Port
range.
Entry Status If enabled, the data is transferred from the public network to the private host, on the
specified ports.

Proxim Tsunami 8000 series Specifications

General

Brand	Proxim
Model	Tsunami 8000 series
Category	Network Router
Language	English