Tsunami
®
800 & 8000 Series - Software Management Guide 72
LCP Echo Failure This parameter indicates the maximum number of consecutive failures to receive the
LCP echo-reply to consider the connection to be down.
To configure LCP Echo Failure value, enter a a value ranging from 1 to 25. By default,
the echo failure is set to 5. On a noisy wireless link, it is recommended to set this value
to higher.
Preferred Service
Name
Specifies the service which the PPPoE server (Access Concentrators) provides to the
PPPoE client.
Leave this parameter blank, if PPPoE client accepts any service offered by the PPPoE
server. To specify the desired service name, enter the service name ranging from 1 to
32 characters.
Access Concentrator
Name
Specifies Access Concentrator (PPPoE server) name.
Leave this parameter blank, when PPPoE client can connect to any PPPoE server on the
network. To connect to a desired PPPoE server, type the server name ranging from 1
to 32 characters.
User Name and
Password
Before establishing a link, the PPPoE server first authenticates the PPPoE client based
on the User Name and Password as shared by the service provider.
Type the user name and password in the User Name and Password box respectively.
You can type user name ranging from 4 to 32 characters and password ranging from
6 to 32 characters.
: User Name and Password parameters are not applicable when the
Authentication Protocol is configured as “None”.
Parameter Description
To Next Page
Loading...
Need help?
General
