Tsunami
®
800 & 8000 Series - Software Management Guide 95
After configuring the required parameters, click OK and then COMMIT.
Security Profile Name The Security Profile Name represents the encryption method used to encrypt the data over
the wireless medium. The default configured Security Profile Name is WORP Security. See
j
.
Radius Profile Name The Radius Profile Name, containing the IP address of the RADIUS server, is used to
authenticate an SU or an End Point B. See
} x v
.
: Not applicable in SU mode and End Point B mode.
MAC ACL Status When enabled, based on the configured Access Control list (ACL), the BSU/End Point A
decides if SU/End Point B can register with them respectively.
: Not applicable in SU mode and End Point B mode.
Radius MAC ACL
Status
This parameter is used to enable authentication using RADIUS server. When enabled, the
BSU or End Point A contacts the RADIUS server for authenticating the SU or End Point B
during the registration process.
: Not applicable in SU mode and End Point B mode.
Poll BackOff on
Timeout
When enabled, the BSU will back-off polling the SUs that timeout (due to interference or
low SNR etc).
When multiple SUs are connected, it is possible that some SUs are performing well without
much retransmissions and other SUs are timing out. In such a
scenario to make sure that
the good SUs do not suffer due to under performing SUs, it is recommended to enable this
parameter.
By default, this parameter is disabled. It is recommended that this parameter should be
enabled only when there is a mix of good and bad SUs and when good SUs are really
suffering.
Error Count Threshold If the error percentage of the transmitted frames is greater than or equal to the configured
threshold, an SNMP trap is generated by the device. For traps, see Reference Guide
available at
j
.
RSSI Drop Threshold Applicable only to an SU/End Point B.
If SNR, on any of the antenna ports, drops by more than or equal to the configured
threshold, an SNMP trap is generated by the SU. For traps, see Reference Guide available
at
j
.
Parameter Description
To Next Page
Loading...
Need help?
General
