Risk of fatal injuries due to explosions or fire.
Never use the controller in areas where there is a risk of explosion.
Install the controller on a non-flammable subsurface.
Risk of fatal electric shock when working on the opened controller.
Make sure that the controller is disconnected from the mains voltage
before removing the terminal cover.
Make sure that the power supply has been secured to prevent it from
being switched on again.
Check that the controller is free from voltage.
Screw the terminal cover securely back in place when work has been
completed.
ATTENTION
Risk of damage and malfunctions due to improper storage before
connection.
Store the controller at room temperature for at least four hours before
connecting it.
Select an installation location which meets the following requirements:
• The installation location must be at eye level.
• The installation location must be close to the storage tank and the solar circuit pump.
• It must have access to the power supply.
• There must be sufficient space in front of the controller to allow it to be operated.
• If you wish to lead cables and lines through the back of the controller, there must be
sufficient space for the cable gland.
To Next Page
Loading...