Prozeda Primos 250 SR - Fastening the Controller

Connecting the controller
12
3.2 Fastening the controller
If you wish to lead cables and lines through the back of the controller, you need to
do this before you fasten it
.
ATTENTION
Risk of damage to the controller housing due to screws tightened too
firmly.
 Tighten the screws only as firmly as necessary.
 Use only suitable screws and dowels for fastening the controller.
 Hang the controller on the top screw by the keyhole (1).
 Fasten the controller with the screws from the inside through the bottom screw holes (2).