10.2 Setting the energy output measurements
The "Basic settings" menu allows you to set the following parameters:
• P:12: Measurement principle for energy output measurement
• P:15: Flow rate for the "Flow indicator" measurement principle
• P:16: Energy output measurement: Glycol type
• P:17: Energy output measurement: Glycol concentration.
11 Restore factory settings
Risk of loss of current settings due to incorrect restoration of the factory
settings.
Before restoring the factory settings, make sure that you no longer
require the current settings.
If necessary, save the current settings to a microSD card before
restoring the factory settings.
The factory settings are the parameters that were preset ex works.
In order to restore the factory settings, select the value "1" in the "P: 35:" menu item in the
"Basic settings" menu.
The factory settings will be restored.
12 Networking the controller with other devices
The RS-485 interface (ProBus and ProBusX) allows you to connect the controller to other
devices in a network. By networking (with the conexio 600 or conexio 200 web module) you
can use the following additional functions via a PC, tablet PC, smartphone etc.:
• Viewing the controller's data on another device (monitoring)
• Operating the controller from another device (remote control)
The manufacturer can provide further details.
To Next Page
Loading...