To Next PageTo Next Page
Need help?Do you have a question about the Prozeda SOLAREG II VISION plus and is the answer not in the manual?
SOLAREG II has integrated over voltage protection on every sensor input. Additional safety measures are usually not required.
No tools are required to open the device. The upper part of the casing is locked to the lower part.
When mounting the device on a wall, proceed as follows: Drill the fixing holes using the drilling template.
The following points must be observed for the 230 V connections: fixed mains connection needs a switch.
The table below shows the allocation of switching outputs for the different system types.
The Solareg Vision Plus devices work with precise platinum temperature sensors of type PT1000.
The control unit records the temperatures from the various measuring points and calculates the correct time to load the storage cylinders.
The storage cylinder is loaded to the specified maximum temperature via the pump on output A1.
The sensors required for the control functions and their connection cables are monitored for breakage and short circuit.
Possible causes and actions for faults recognised by the control unit and indicated by error messages.
Troubleshooting faults that are not indicated by the control unit's error messages.
General| Manufacturer | Prozeda |
|---|---|
| Category | Controller |
| Model | SOLAREG II VISION plus |
| Device Type | Solar Charge Controller |
| MPPT Technology | Yes |
| Nominal Battery Voltage | 12 V / 24 V |
| Display | LCD |
| Protection Features | Overload, Short Circuit, Reverse Polarity, Over Temperature |
| Efficiency | 98% |
| Battery Type Compatibility | Lead-acid (Flooded, Gel, AGM) |
