Installation and Operating Instructions
SDC 204 1316BED035-10B-E Date 12/06
- 9 -
5.2 Wall mounting
When mounting the device on a wall,
proceed as follows:
• Drill the fixing holes using the drilling
template shown.
• Screw in the two top screws leaving
a gap of up to 6 mm.
• Open the device as described and
hang it on the two screws. You can
now fit the two bottom screws.
• To avoid damage to the lower part
of the casing, do not over tighten
any of the screws.
126mm
118mm
You drill into walls at your own risk. Prior to drilling, please check that there
are no cables, pipes or shafts in the wall; contact the property owner if
necessary.
To Next Page
Loading...
