PT200MI instruction manual 11
5.1.14 "F13 0" BCD OUTPUT RATE
Press TARE key to select, ZERO to accept.
0 = 4 times/sec 1 = 8 times/sec 2 = 16 times/sec 3 = 20 times/sec
4 = 60 times/sec 5 = 80 times/sec 6 = 100 times/sec 7 = 200 times/sec
Note: There is no need to set this without the BCD board option.
5.1.15 "F14 0" RS485 ID CODE
Press TARE key to select, ZERO to accept.
00 ~ 99
Note: This parameter will be activated only for the RS485 option.
The ID code must not be the same as any other PT200MI which connected
to the same master device.
ID = 00, only single device communication.
5.1.16 "F15 0" PEAK HOLD
Press TARE key to select, ZERO to accept.
0 = Peak hold is not valid 1 = Peak hold(automatically) 2 = Valley hold(automatically)
3 = Peak – valley hold(automatically) 4 = Peak hold(external) 5 = Valley hold(external)
6 = Peak – valley hold(external)
Note: 4, 5 or 6 must coincide with a setting of “8 = Peak hold” for F16, F17 or F18.
5.1.17 "F16 0" INPUT 1
Press TARE key to select, ZERO to accept.
0 = Function 1 = Zero 2 = Tare 3 = Gross/Net 4 = Print 5 = kg/lb
6 = On/Off 7 = Hold 8 = Peak hold
5.1.18 "F17 0" INPUT 2
Press TARE key to select, ZERO to accept.
0 = Function 1 = Zero 2 = Tare 3 = Gross/Net 4 = Print 5 = kg/lb
6 = On/Off 7 = Hold 8 = Peak hold
5.1.19 "F18 0" INPUT 3
Press TARE key to select, ZERO to accept.
0 = Function 1 = Zero 2 = Tare 3 = Gross/Net 4 = Print 5 = kg/lb
6 = On/Off 7 = Hold 8 = Peak hold
5.1.20 "F19 0" COMPARISON CONDITION
Press TARE key to select, ZERO to accept.
0 = Gross weight 1 = Net weight 2 = Display weight
Note: The comparison condition is the weight that will be compared against the set-points.
To Next Page
Loading...
