At this point, the basic parameters required for operation have been
entered. If no other options are active or required, you can exit the
setup mode. Following are optional parameters to customize the
feel of the site.
NOTE: Several options allow the setting of time in seconds. When
minutes are desired, multiply the number of minutes by 60 to get
the number of seconds. For example: 3 minutes × 60 seconds per
minute = 180 seconds.
Change the Setup
Password?
Press * for YES
Press # for NO
Allows you to change the setup password
from the factory default of 8898. When
YES is selected, the unit will prompt for the
new password. The new password must be
entered twice for verification before it will be
changed. If both passwords entered match,
the password will be changed. Otherwise, a
message will indicate that the passwords do
not match.
Tamper Sensor is: ENABLED
Press * to Change
PRESS # WHEN DONE
Controls the use of the tamper sensor.
Options are ENABLED and DISA BLED. If
enabled, the keypad will not function and
an alarm will occur from the controller if
the unit is tampered with. Factory default is
ENABLED.
Secure Code Entry?
NO
Press * to Change
PRESS # WHEN DONE
Controls the characters displayed during
code entry. When set to YES, the display will
show only * for each key pressed. When set
to NO, the numbers pressed will be echoed
to the display. Factory default is NO.
Beep with Key Press?
YES
Press * to Change
PRESS # WHEN DONE
Controls the internal buzzer used to provide
audio feedback for any key press. When set
to YES, the buzzer will produce a short beep
when a key is pressed. When set to NO, the
buzzer will not sound with key presses.
Factory default is YES.
Beep with Access?
YES
Press * to Change
PRESS # WHEN DONE
Causes the internal buzzer to sound when
access is attempted. A valid access will
cause the buzzer to sound one long beep.
All other attempts will cause the buzzer to
sound four short beeps. Factory default is
YES (on).
APEX Access Device
34
114A3863.E rev. 7-2017
To Next Page
Loading...
