How to Stop Engine
How to Attach Electronic Devices
1. Before Starting generator
•
•
•
•
Make sure the generator is grounded (see page 10 for instructions).
Make sure the attached load is within the generator rated output and the receptacle’s rated current.
Make sure all electrical cords and receptacles are in good condition.
Make sure all electronic devices are turned “OFF” before plugging them into the generator.
2. Start engine
3. If the attached load is small, turn the Economy switch to the “ON” position. For a larger load, or if attaching multiple
electronic devices turn the Economy switch to the “OFF” position.
4. Make sure the green AC pilot indicator light is on.
.
6. Allow generator output to stabilize (engine and attached devices run evenly) before plugging in the next load.
14
WARNING!
Never start or stop engine with electrical devices plugged in to the receptacles. Failure to
do so could damage the generator and / or connected electrical devices.
•
Always start the engine and let it stabilize before connecting any electronic devices.
•
Disconnect all electronic devices before stopping the engine.
CAUTION!
If you choose one push start key or remote control to stop the generator, please press the power
switch to "OFF" position at the end.
• Turn the ｅ｣ｯｮｯｭｹ switch to the “OFF” position.
• Disconnect any electronic device. All loads MUST be disconnect from the generator. Never start or stop the engine
with electrical devices plugged in to the receptacles.
• Turn the Start Switch to the “OFF” position.
• Turn the fuel supply to the “OFF” position.
To Next Page
Loading...
Need help?
General
