To clean, remove screws, remove outer casing, and drain fuel.
Lift and hold onto the clamp, then remove hose from tank.
Install hose and clamp.
Open fuel valve. Inspect for leakage.
Install outer casing and tighten screws.
Storage and Trans portation of the Generator:
When transporting the generator, please keep the fuel cap on “OFF” to storage.
Remove any debris that has collected on the generator and around the muffler and control panel. Use a brush or vacuum
to remove loose dirt.
Inspect air cooling slots. Remove any debris if obstructed.
For short-term storage, start the generator once every 7days.
For semi-long term storage, add fuel stabilizer to prevent stale fuel from causing acid and gum deposits in the fuel system
and carburetor.
For long-term storage, drain the fuel.
Store indoors to prevent freezing and use aprotective cover to protect from dust.
The generator must be Shipped, Run, and Stored in the upright position as seen
in this image.
22
To Next Page
Loading...
Need help?
General
