Pulsar PGD105TiSCO - Safety Instructions; Operational Location and Practices; Operating Procedures

3
Safety Instructions
Correct Usage
Example location to reduce risk of carbon monoxide poisoning
● ONLY use outside and downwind, far away from windows,
doors, and vents.
● Direct exhaust away from occupied spaces.
Incorrect Usage
Do not operate in any of the following locations:
● Near any Door, Window, or Vent
● Garage
● Basement
● Crawl Space
● Living Area
● Attic
● Entry Way
● Porch
● Mud Room
WARNING
Starter cord kickback (rapid retraction) could pull hand and
arm toward the engine faster than you can let go which could
cause broken bones, fractures, bruises, sprains, or other
serious injuries.
WARNING
Fuel and its vapors are extremely ammable and explosive
which could cause burns, re, or explosion resulting in death
or serious injury and/or property damage.
When Adding Or Draining Gasoline
Turn the generator engine OFF and let it cool for at least 2 minutes
before removing the fuel cap. Loosen the cap slowly to relieve
pressure in the tank.
● Fill or drain fuel tank outdoors.
● DO NOT overll the tank. Allow space for fuel expansion.
● If fuel spills, wipe it up and let the area dry before starting the
engine.
● Keep fuel away from sparks, open ames, heat, and other ignition
sources.
● Check fuel lines, tank, cap, and ttings frequently for cracks or leaks;
replace if necessary.
● DO NOT light a cigarette or smoke anything.
When Starting Equipment
● Ensure spark plug, mufer, fuel cap, and air cleaner are in place.
● DO NOT crank engine with spark plug removed.
When Operating Equipment
● DO NOT operate this product inside any building, carport, porch,
mobile enclosure, marine applications, or shed.
● DO NOT tip engine or equipment at an angle that causes fuel to spill.
● DO NOT stop the engine by moving the choke control the to "Start"
position.
● DO NOT exceed the generator's wattage capacity.
● Start the generator and the let engine stabilize before connecting
electrical loads.
● Connect electrical loads in the OFF position, then turn ON for
operation.
● Turn electrical loads OFF and disconnect from the generator before
stopping the generator.