5.2.6 Replacing the drive wheel, indoor/outdoor Puma 40
Preparation
• Switch off the wheelchair via the remote control.
• Be sure that the freewheel switch is in ‘drive’ mode. If
the freewheel switch is in ‘push’ mode this will make
loosening the bolts impossible.
• Use a lifting device to raise the drive wheels clear of the
ground.
Instructions
• Remove the cap, unlock the locking plate, remove the bolt
and the locking washer.
• Replace the new drive wheel.
• Screw the bolt with ring and a new locking plate into the
shaft, lock the locking plate and put the cap back again.
• Check the tyre pressures.
Notice
Infl ate the tube to the correct pressure! (See ‘Technical
specifi cations’)
Relevant article numbers
9006008 Drive wheel mounting set, Puma 40
1017008 Drive wheel indoor 12 1/2 x 2 1/4 (13"), air
1017442 Drive wheel indoor 12 1/2 x 2 1/4 (13"), air, set
1017009 Drive wheel indoor 12 1/2 x 2 1/4 (13"),
punctureproof
1017443 Drive wheel indoor 12 1/2 x 2 1/4 (13"),
punctureproof, set
1017010 Drive wheel outdoor 3.00x8 (14"), grey air
1017440 Drive wheel outdoor 3.00x8 (14"), grey air, set
1017011 Drive wheel outdoor 3.00x8 (14"), grey
punctureproof
1017441 Drive wheel outdoor 3.00x8 (14"), grey
punctureproof, set
1017046 Drive wheel silver-grey outdoor 3.00x8 (14"), grey
air, All Weather
1017012 Drive wheel outdoor 3.00x8 (14"), black air
1017446 Drive wheel outdoor 3.00x8 (14"), black air, set
1017013 Drive wheel outdoor 3.00x8 (14"), black
punctureproof
1017447 Drive wheel outdoor 3.00x8 (14"), black
punctureproof, sett
Tools used
• Lifting device
• Screwdriver
• Hammer (plastic)
• Torque wrench, socket, 13 mm
• Water pump pliers
Icons
Parts need to be replaced. Dispose of waste parts in
accordance with local regulations
Bolts are provided with Loctite thread locker!
Note! Be aware of the issue!
1
Note! Suitable work area required!
2
Service instructions | 67
Puma 20/40/60
Service instructions | 67
/60
To Next Page
Loading...