What does it mean if ON/OFF light flashes 7 times on Puma 20 Wheelchair?
If the ON/OFF light flashes 7 times, there may be a fault in the controller. Check all connections and correct as necessary. If the fault signal persists, replace the power module.
What does it mean if ON/OFF light flashes 8 times on Puma 20?
If the ON/OFF light flashes 8 times, there is a fault in the power module. Check all connections and correct where needed. If the fault signal continues, replace the power module.
General| Backrest Height | 40 cm |
|---|---|
| Frame Material | Aluminum |
| Foldable | Yes |
| Seat Width | 40 cm |
| Armrest Height | 22 cm |
Manual content, training requirements, and ordering parts information.
Details on the product's identification plate.
Explains warning and reference symbols.
Weight limits when Puma 20 options are installed on Puma 40/60.
Requirements for service technicians and trainees.
General safety information with warning symbols.
Importance of decals and symbols on the wheelchair.
Specific warnings for crushing and finger entrapment hazards.
List of tools required for mechanical adjustments and maintenance.
Tools required for electronic settings and programming.
How to order parts, specifying required information.
Diagram and list of carrier and seat components for adjustment.
Details and part numbers for the battery tray and suspension interface.
Parts and diagram for the Dahl car docking system for FWD.
Parts and diagram for the Dahl car docking system for RWD.
Parts and diagrams for suspension arms and motors for Puma 20.
Parts and diagrams for suspension arms and motors for Puma 40/60.
Parts and diagrams for castor forks and wheels for Puma 20.
Parts and diagrams for castor forks and wheels for Puma 40/60.
Parts and diagram for covers specific to the Puma 20 model.
Parts and diagram for covers specific to the Puma 40/60 models.
Parts and diagram for tilt modules used in Puma 20.
Parts and diagram for tilt and lift modules for Puma 40/60.
Parts and diagram for the kerb climber accessory.
Parts and diagram for the direct access feature.
Parts and diagram for the attendant Z-steering system.
Wiring and module information for the Shark system.
Wiring and module information for the R-net system.
Wiring and module information for the DX2 system.
Wiring and module information for the VR-2 system.
Periodic checks and their frequency, User/Supplier responsibility.
General overview of instructions for assembly, replacement, and adjustments.
Procedure for replacing Puma 20 motors, noting compatibility.
Steps to convert the wheelchair between FWD and RWD configurations.
Instructions for mounting the kerb climber, specifying RWD use.
Procedure for replacing carbon brushes in the motors.
Steps to replace indoor/outdoor drive wheels on Puma 20.
Steps to replace indoor/outdoor drive wheels on Puma 40.
Procedure for replacing the tube or tyre on drive wheels.
Steps for replacing castor wheels on the wheelchair.
Procedure for replacing the tube or tyre on castor wheels.
Steps for replacing the castor fork assembly.
Instructions for installing the direct access keypad.
Instructions for mounting attendant steering on Sedeo Pro+ backrest frame.
Instructions for mounting attendant Z-steering for Norwegian market.
Procedure for replacing the wheelchair batteries.
Steps to replace the power module of the wheelchair.
Instructions for replacing the mudguards.
How to replace colored covers on the wheelchair.
Procedure for replacing anti-tip wheels and brackets.
Steps to adjust the seating height of the wheelchair.
How to adjust the wheelchair's center of gravity.
Procedure for adjusting the mechanical seat tilt.
How to adjust the electrical seat tilt to 0-25 degrees.
How to adjust the minimum angle for electrical seat tilt.
How to adjust the maximum angle for electrical seat tilt.
Tables detailing seat tilt limitations based on various settings.
Troubleshooting steps for castor wheel shimmy issues.
Troubleshooting table for the Shark system.
Troubleshooting table for the R-net system.
Troubleshooting table for the DX2 system.
Troubleshooting table for the VR-2 system.
Compliance with medical device directives and relevant standards.
Specifications for batteries and wheelchair models.
Guidelines for cable routing and diagrams for electrical connections.
Glossary of terms used in the warranty section.
Table outlining warranty periods for different wheelchair components.
To Next Page