28
Listening to Internet Radio and more EVOKE Flow Owner’s Manual v1.0
Encryption The encryption method is listed (WEP, WPA or WPA2).
IP address The IP address of the radio.
Net mask The configured network mask.
DNS The DNS server IP address.
Router The gateway router IP address.
Radio Name The name of the radio (see Change radio name)
MAC address The MAC address of the radio (a fixed address that identifies your hardware).
Access point The MAC address of the wireless router that the radio is connected to.
Manual setup
Select ‘Manual setup’ to manually configure your wireless network settings (for advanced users only).
Retry connection Attempts to reconnect to the selected network.
Network name Choose from ‘Scan for networks’ or ‘Enter SSID manually’ to specify a new SSID
for your wir
eless network.
Encryption mode Change the encryption mode between ‘WEP’, ‘WPA (PSK)’, ‘WPA2 (PSK)’ or
‘None’. EVOKE Flow automatically detects the encryption mode for your network.
Only change this setting if you think the encryption mode has been specified
incorrectly.
Key or password Enter a new encryption key or password.
IP address Choose between ‘DHCP’ or ‘Static’.
Clear network settings
Select ‘Clear network settings’ and EVOKE Flow will ‘forget’ all wireless networks and perform a
fresh re-scan for visible networks. Select ‘Connection wizard’ to re-scan for wireless networks. Note
that you will have to re-enter your WEP or WPA/WPA2 key or password. You have to confirm this
operation: tap O Yes to confirm or O No to cancel.
To Next Page
Loading...
