41
Universal options EVOKE Flow Owner’s Manual v1.0
To adjust the screen brightness
By default, the display brightness is set to ‘Automatic’ in active and standby, which means that the
brightness adjusts to suit the lighting level in your room. If you want to change this setting, follow the
instructions below:
1 Tap O Options and highlight and select ‘Display’.
2 Highlight ‘Active operation’ to adjust the display settings that apply when the radio is switched
on or ‘Standby operation’ to adjust the display settings that apply in standby.
3
Highlight and select ‘Brightness’.
4
Rotate the Select dial to adjust the brightness from 1 (low) to 10 (high) and tap O OK to confirm.
Note
You can toggle the brightness between O Automatic (light sensor) and O Manual.
7.5 Upgrade your radio’s firmware
Firmware upgrades may be issued in the future to provide exciting new features. You can check if a
firmware upgrade is available and download the upgrade over your wireless network. Alternatively,
you can connect EVOKE Flow to your PC using a USB cable (A-to-mini-B type, not supplied) and
download the firmware upgrade manually from www.pure.com/support.
To upgrade over your wireless network (recommended)
1 Tap O Options; highlight and select ‘Additional settings’; select ‘Upgrade’; and select ‘Wi-Fi’.
2 EVOKE Flow will search for any available upgrades.
3 If an upgrade is available the message ‘New version available: v1.x’ will appear on screen. In
the event that older softwar
e upgrades, which have been superceded by the new upgrade, are
available tap O Show all to display all the available (legacy) upgrades.
4 Tap O OK to download and install the new firmwar
e, which takes 3–4 minutes.
To upgrade using a USB cable (where a wireless network is not available)
1 Visit www.pure.com/support to check to see if an upgrade is available for EVOKE Flow.
2 If an upgrade is listed on the website, download the most recent upgrade to your PC.
3 Connect EVOKE Flow to your PC’s USB port. Follow the on-screen instructions provided with
the upgrade software.
7.6 Factory reset
Resetting your radio removes all DAB and FM presets (but not your internet Favourites), clears the
DAB station list and resets all options to defaults. All your wireless networks settings will be cleared.
1. Press and hold O Options for 3 seconds to display the ‘Factory reset’ menu.
2. Tap O Yes to confirm the reset or O No to cancel, or wait 7 seconds for the screen to time-out.
Note
If you only want EVOKE Flow to forget all wireless networks, not your other settings, you
can select ‘Clear network settings’ in the ‘Wi-Fi settings’ menu.
To Next Page
Loading...
