OPER
ATING MANUAL FOR SELECT ANALYST
Issue: A, part number R041118
25
7 TROUBLE SHOOTING
The touch screen will display various alarms and/or error messages if a fault
is identified with the unit. The guide below can be used to rectify common
alarms.
Displayed Message Corrective action
LHS pack not fitted
Check left hand side media
pack is correctly located.
Push into position and listen
for a click to ensure it is fully
located in it retaining block
RHS pack not fitted
Check right hand side media
pack is correctly located.
Push into position and listen
for a click to ensure it is fully
located in it retaining block
High pressure (BP) variants
only
Feed water inlet pressure too
high.
Blockage in system
Check feed water supply
regulation
Call service department
Low pressure(BP) variants
only
Insufficient feed water
pressure
Check feed water supply
Check inlet screen
Change Puripac
Puripac cartridge exceeded
set date alarm or water
quality above set limits
Replace media packs and
reset system dates
Line cell error Faulty cable – open circuit Call service department
To Next Page
Loading...
