OPER
ATING MANUAL FOR SELECT ANALYST
Issue: A, part number R041118
8
3.5 Bringing the system to a stop in the event of an
emergency
Switch off via the display.
Turn off the electrical supply.
Shut off the water supply.
After remedying the damage:
Open the water supply.
Turn on the electrical supply.
Restart the unit via the main display.
3.6 Safety information for maintenance tasks
The operator must take care to ensure that all maintenance, inspection
and assembly tasks are performed by authorised and qualified
professionals who have been sufficiently informed regarding the task at
hand (via use of Operating Manual).
The system must be shut down and be protected from further use until all
repair and maintenance tasks have been completed. It is essential to
observe the shutdown procedure as described in this Operating Manual.
Before beginning tasks relating to electrical equipment/components of this
system, a check must confirm that power has been disconnected from the
corresponding section of the system. In addition, the system must be
secured to prevent it from being turned on again unintentionally.
3.7 Disposing of system parts and operating materials
When they need to be discarded, consumables must be disposed of
according to local and National requirements.
3.8 Unauthorised conversion and manufacturing
replacement parts
Conversion or modification of the system is only permitted with the
approval of the manufacturer. The same applies to making changes in the
programming for the control system. Original replacement parts and
accessories authorised by the manufacturer enhance safety. Use of other
parts will void the warranty.
To Next Page
Loading...