EasyManua.ls Logo

Purite SELECT HP - 8.6 Drain connection; 8.7 Installation of media cartridge packs

Purite SELECT HP
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SELECT HP USER INSTRUCTIONS
Issue: A, part number L300954
42
8.6 Drain connection 6 Drain connection
Attach a suitable length of 8mm tubing to the drain connection so that the
free end may be inserted into an appropriate drain. The tubing must not be
kinked or the flow restricted in anyway.
Attach a suitable length of 8mm tubing to the drain connection so that the
free end may be inserted into an appropriate drain. The tubing must not be
kinked or the flow restricted in anyway.
If the drain is to be run over 5 metres and/or rises above the level of the unit
then contact our Service Department for advice.
If the drain is to be run over 5 metres and/or rises above the level of the unit
then contact our Service Department for advice.
Attach a suitable length 12mm hose to the overflow connection on the unit
and run to a suitable drain point. The drain must be lower than the unit
Attach a suitable length 12mm hose to the overflow connection on the unit
and run to a suitable drain point. The drain must be lower than the unit. If the
drain is to be run over 5 meters and/or rises above the level of the unit then
contact our Services Dept for advice.
8.7 Installation of media cartridge packs
Remove the door of the unit by pulling gently on the hand hold provided in the
door.
Remove the cartridge media packs from their packaging and remove the
black protective caps from the inlet and outlet ports.
Insert the Pretreatment (PT8 or PT16) in the left hand retaining block
pushing it home until it clicks into position and retaining mechanism clicks up.
Insert the Puripac PP8 or PP16 pack in the right hand retaining block pushing
it home until it clicks into position and retaining mechanism clicks up.
Replace the front cover by locating the top of the cover under the retaining
mouldings and lifting the bottom of the cover until it slides in fully.
Switch on water supply to the unit.
Switch on the electrical supply to the unit.
Reset both pack dates as instructed.
This touch screen display will illuminate and display the start screen.