Figure 10. AP detail
3.3. AC management via PUSR cloud
This function is used to manage AP devices connected to PUSR cloud(the AP devices need to be connected to
the Internet). You need to import the SN code and cloud password of the corresponding device. It contains four
sub-menu bars: AP list, AP settings, AP details, and AP import.
3.3.1. AP import
Import the SN code and cloud password of the AP device on this page to enable the AC to remotely manage
the AP through the PUSR cloud. There are two ways to import: manual adding and file import, as shown in the
figure below. The content format of the imported file is as shown in the chapter. After successful import, and the
AP device has been successfully added on the cloud platform, it will be displayed in the AP list after refreshing
the page.
To Next Page
Loading...