Memory clean
Cleaning up memory speeds up the system.
Desktop wallpaper
According to your personal preference, you can go from "wallpaper" to "dynamic wallpaper" the "gallery"
sets the wallpaper as prompted.
WLAN (Wi-Fi settings)
Click “ ” to switch from OFF to ON.
After searching for nearby wireless Wi-Fi, select the Wi-Fi hotspot you want to connect from the list.
Enter your wireless connection password in the pop-up password box, then click "Connect". Enter the
correct password, it will connect successfully after a while and display "connected."
Reset
Reset Network: This will reset all network settings, including (WLAN, Mobile Data Network, Wireless BT)
Restore factory settings: This will restore the system to factory settings and clear all data in your device's
memory.
Time setting
Determining the date and time automatically can be turned on, optionally using the network or provided by
GPS. If you need to adjust the time manually, it need to be switched o, click directly to mobilize the time or
date. Determining the time zone automatically can also be opened. It can be manually adjusted after
switching o. It can also open or close the 24-hour system.
Troubleshooting
Q: Unit doesn’t power up.
A: Use a multi-meter to check for 12v+ to red and yellow wires. Check for proper Ground on the Black wire.
Q: My video does not play.
A: Attach “PARK” wire to parking break. When this wire is grounded the video will play
(Grounding trigger of the parking brake)
Q: Reverse camera does not come up on the screen.
A: Attach “BACK UP CAMERA” wire to reverse tail light 12v+ (Make sure camera is and sending video signal)
Q: Can I set up steering wheel control?
A: Key 1 and Key 2 wires need to be wired to your vehicle’s steering wheel column
Q: The time I set is not saved after device reboot.
A: Are other setting saved? If not: Check that yellow memory wire is attached to 12v+ constant
A: Turn o GPS auto update
Go to radio settings > Set Time > switch o auto update
www.PyleUSA.com
7
To Next Page
Loading...
Need help?
General
