Name: Pylontech Force-L2
Brand: Pylontech
Rating: 4 (1 reviews)

Other manuals for Pylontech Force-L2

Product Manual15 pages

Questions and Answers:

C
Cory RossJul 27, 2025
Why is the status LED light on orange on my Pylontech Storage?
- M
  Michael DaviesJul 27, 2025
  If the status LED on your Pylontech Storage system is orange, it indicates an error with the controller module. Try restarting or replacing the controller. It could also mean a cell, module, or controller is under protection. In this case, check the battery LED and debug. Press the start button for 10 seconds; if there's power output, charge the system. If not, use a debug tool for further checking. If these steps don't resolve the issue, replace the controller.
D
Dylan CoxJul 31, 2025
What to do if all 7 batteries LEDs flash orange on Pylontech Storage?
- K
  Keith WebbJul 31, 2025
  If your Pylontech Storage system shows all 7 batteries LEDs flashing orange, it indicates an address distribution failure. Try changing the controller. Alternatively, remove the battery modules one by one and restart the system until it works. The last module removed is likely the faulty one.
D
Dawn MccoyAug 4, 2025
What to do if the status led slow flash orange on Pylontech Force-L2?
- K
  kevin11Aug 4, 2025
  If the status LED on your Pylontech Storage is slowly flashing orange, it means the voltage or temperature is too low or too high. If the temperature is abnormal, put the battery system in a normal environment and wait for the protection to release. If the temperature is normal, disconnect the power cable and try a black start operation. If it works, monitor the voltage at the DC terminal; if it's too low, turn off the system and charge it. If the black start doesn't work, use a debug tool for further checking.
C
Christopher TaylorAug 9, 2025
What to do if a single battery LED light on orange on Pylontech Force-L2 Storage?
- M
  Morgan MooreAug 9, 2025
  If a single battery LED is lighting up orange on your Pylontech Storage, it indicates a battery module failure or that it is under protection because the cell or module voltage or temperature is too low or too high. To resolve this, charge the system using an inverter or charger (53.5V, ? 10A). If it returns to normal, the system is working. If not, replace the battery module.
G
glassjamesAug 13, 2025
How to fix no power output and no led on in Pylontech Storage?
- D
  Darrell BradyAug 13, 2025
  If your Pylontech Storage system isn't providing power and no LEDs are lit, it could be due to several reasons. First, ensure you press the start button for at least 2 seconds. If that doesn't work, the button battery in the controller might be missing or the power supply in the controller might have failed, in which case you should change the controller module. Another possibility is that the battery voltage is too low, requiring you to change the first battery module.

Pylontech Force-L2 Specifications

General

Battery Type	Lithium Iron Phosphate (LiFePO4)
Nominal Voltage	51.2 V
Capacity per Module	3.55 kWh
Usable Energy	3.2 kWh
Operating Temperature	-10°C to 50°C
Communication Interface	CAN, RS485
Warranty	10 years
Peak Discharge Current (3 sec)	100 A
Protection Degree	IP20
Cycle Life	6000 cycles at 80% DoD