EURO 46 Installation Manual
Page: 9
3.1 Technical Specification
Programmable
Outputs Power Rating Normal State Active State
PGM 1 Relay, 3A, max 30V Changeover NC & NO Changeover NC & NO
Speaker 16 ohms No tones Repeat RKP tones & internal sounder
Strobe Output 500mA 12v 0v
Bell Output 500mA 12v 0v
XPGM 1 (Input 7) 50mA Floating 0v
XPGM 2 (Input 8) 50mA Floating 0v
ATE Outputs 2mA 5v 0v
All outputs are programmed in "CHANGE OUTPUTS" in the Engineer menu.
Input Resistance 1k / 1k DEOL Range 4k7 / 2k2 DEOL Range 4k7 / 4k7 DEOL Range
Normal 0k5 to 1k4 1k4 to 2k9 3k7 to 8k3
Burglary Alarm 1k5 to 5k9 4k2 to 7k8 8k4 to 10k2
Fault 6k to 8k1 8k to 11k3 10k3 to 14k9
Masking (6k8) 8k2 to 17k 11k6 to 22k 15k to 22k
Tamper <0k5 or <17k <1k4 or >22k <3k7 or >23k
All inputs are programmed in "PROGRAM INPUTS" in the Engineer menu.
Fuses Value Type
Bell Fuse for bell terminals F800mA quick blow 250V Glass
Aux Fuse for aux terminals F800mA quick blow 250V Glass
RS485 Bus Fuse for bus terminals F800mA quick blow 250V Glass
Battery Fuse for battery terminals T1.6A slow blow 250V Glass
230V Mains Fuse for mains terminals T500mA H anti-surge slow blow 250V Ceramic
Panel Power Supply Output Nominal Range
Output Voltage 13.7V DC 10-15V DC
Output Current EURO 46S 1A Continuous 1.5A peak, during battery charging
Output Current EURO 46L 1.5A Continuous 2.0A peak, during battery charging
Power Supply Type A.
Maximum output peak voltage: Max 100 mV
SD Voltage which the deep discharge protection function will operate at: 10.5V
Over Voltage Protection Trigger Voltage: 18V
NOTE 1. EURO power supplies are NOT designed for use with multiple batteries connected.
NOTE 2. System load should not exceed the panel power supply output shown above or the maximum load
supportable by the battery for the specified backup time, as in the table shown below.
NOTE 3. The power ratings are based on battery shown in table – but ANY battery capable of supporting the
system load for the required time may be used without affecting these ratings.
Panel Power Supply Input Nominal Range
Mains Supply Voltage AC 230V AC at 50Hz -15% +10%
Transformer Rating EURO 46S 18VA 18V at 1.0A
Transformer Rating EURO 46L 45VA 18.5V at 2.5A
Battery Charging Specification
Float Voltage 13.8v DC Control Panel Type
Battery low voltage cut off 10.5v
Standby battery capacity
current 300mA (3A to 7A)
Recharge time <24 Hours
Standby battery capacity
current 700mA (8A to 17A)
To Next Page
Loading...
