10
Unsetting your Euro 46 APP panel
There are four ways that you can unset your system.
Enter your user code and select any areas that are to be unset, then press the button as shown below:
Press the unset ( >) button on the
keyfob and then release, the keyfob will
unset the areas it has been assigned to
by your installer.
Present your tag and select any areas
that are to be unset, then press the
button (presenting a tag takes
you straight to the ‘Unset Areas’
screen in the diagram above)
NOTE: Options 1 & 2 only function if ‘Flexi Unset’
has been enabled by your engineer. If it has not
been enabled, then all areas allocated to your
user code will unset.
NOTE: Your system may
not have a wireless ZEM
installed - and therefore
not have keyfobs.
NOTE: The keyfob
buttons can be
programed in the Master
Manager ‘CHANGE
CODES’ menu by going
to ‘Delete/Change User’
and selecting keyfob
from the list of users.
100%9:41 AM
Open the HomeControl+ App
on your mobile device and sign
into your system with your user
code and password details. Then
touch the red (set) padlock
icons to turn
them to green
padlock icons and
unset those areas.
NOTE: Please see the
App guide for further
details or contact
your installer.
2. 3.
4.
1.
Default Master Manager Code: 2 2 2 2
We highly recommend that this is changed.
OR - User code given by your installer.
YES YES
Euro 46 App
Time 02:11 c
Euro 46 App
Time 02:11 c
Enter Your Code
[******]
Unset Areas
[01ABCD]
Press the 0, 1, A, B, C, or D keys
to select the area to be set
User
Code