Chime Feature: HU Alarm from keypad:
This feature can be set up by your installer and
is most commonly enabled for doors using the
magnetic contact. When activated you will hear
a ‘chime’ sound to alert you whenever the door
is opened.
To disable the chime on the your panel keypad,
simply close all doors that chime and when ‘c’ is
displayed, press the c key. Press the c key
again to re-enable the chime.
With the standard Euro Keypad, if you require a Hold-Up (HU)
alarm, press and hold both the 1 and 7 keys for 3 seconds and
a ‘HU’ alarm will be generated.
If you have the Surface or ush mount keypad (pictured on the
right below) then it has a dedicated HU Alarm button - hold this
for 3 seconds to generate a HU Alarm
Note: The HU feature must be enabled by your engineer (silent or
audible alarm options available).
+
To Next Page
Loading...
Need help?
General
