Shanghai Pytes Energy Co., Ltd
General Requirements
⚫ The installation and usage environment must meet relevant international, national,
and local standards for lithium batteries, and are in accordance with the local laws
and regulations. The user is obliged to protect the battery against fire or other
hazards.
⚫ The E-BOX 48100R is IP 20 degree, please install it indoors or in a suitably rated
outdoor enclosure.
⚫ Keep the Battery out of the reach of children and away from daily working or living
areas, including but not limited to the following areas: studio, bedroom, lounge, living
room, music room, kitchen, study, game room, home theater, sunroom, toilet,
bathroom, laundry, and attic.
⚫ When installing the battery in a garage, keep it away from the driveway. It is
recommended that the battery be mounted on the wall higher than the bumper to
prevent collision.
⚫ Do not install the battery in places that are enclosed, unventilated, or difficult for
firefighters to access. Do not place flammable or explosive materials around the
battery. It is recommended that the battery be mounted on a wall to avoid contact
with water.
⚫ Install the battery in a sheltered place or install an awning over it to avoid direct
sunlight or rain.
⚫ For areas prone to natural disasters such as floods, debris flows, earthquakes, and
typhoons, take corresponding precautions for installation.
⚫ Do not install the Battery in an easily accessible position because the temperature of
the enclosure and heat sink is high when the System is running.
⚫ Do not install the Battery on a moving object, such as ship, train, or car.
⚫ Ensure that the equipment is stored in a clean, dry, and well-ventilated area with
proper temperature and humidity and is protected from dust and condensation.
⚫ Keep the installation and operating environments of the equipment within the
allowed ranges. Otherwise, its performance and safety will be compromised.
⚫ Do not install the equipment in an environment with direct sunlight, dust, smoke,
volatile or corrosive gases, infrared and other radiations, organic solvents, or salty
air.
⚫ Do not install the equipment in an environment with conductive metal or magnetic
dust.
⚫ Do not install the equipment in an area conducive to the growth of microorganisms
such as fungus or mildew.
⚫ Do not install the equipment in an area with strong vibration, noise, or
electromagnetic interference.
⚫ Ensure that the site complies with local laws, regulations, and related standards.
⚫ Ensure that the ground in the installation environment is solid, free from spongy or
soft soil, and not prone to subsidence. The site must not be located in a low-lying
land prone to water or snow accumulation, and the horizontal level of the site must
To Next Page
Loading...
