Shanghai Pytes Energy Co., Ltd
⚫ Over voltage control
⚫ Over current control
⚫ High/Low temperature control
⚫ Short Circuit control
⚫ Reverse connection control
Management and monitoring
⚫ Cell Balance control
⚫ Intelligent charge algorithm
⚫ Charge/Discharge current limit
⚫ Capacity retention calculation
⚫ Administrator monitoring
⚫ Event and history monitoring
3 Transportation and Storage
3.1 Transportation Requirements
Load or unload batteries with caution. Otherwise, the batteries may be short-circuited or
damaged (such as leakage and crack), catch fire, or explode.
Do not move a battery by holding its terminals, bolts, or cables. Otherwise, the battery
may be damaged.
Keep batteries in the correct direction during transportation. They must not be placed
upside down or tilted, and must be protected against falling-down, mechanical impact,
rains, snows, and falling into water during transportation.
Before unpacking, storage, and transportation, ensure that the packing cases are intact
and the batteries are correctly placed according to the labels on the packing cases. Do
not place a battery upside down or vertically, lay it on one side, or tilt it. Stack the
batteries according to the stacking requirements on the packing cases. Ensure that the
batteries do not fall or get damaged. Otherwise, they will need to be scrapped.
⚫ Batteries have obtained the certifications of the UN38.3. The batteries belong to
To Next Page
Loading...
