Shanghai Pytes Energy Co., Ltd
1 Safety information
1.1 Personal Safety
Ensure that power is off during installation. Do not install or remove a cable with power
on.
Non-Standard and improper operation on the energized equipment may cause fire,
electric shocks, or explosion, resulting in property damage, personal injury, or even
death.
Before operations, remove conductive objects such as watches, bracelets, bangles,
rings, and necklaces to prevent electric shocks.
During operations, use dedicated insulated tools to prevent electric shocks or short
circuits. The dielectric withstanding voltage level must comply with local laws,
regulations, standards and specifications.
During operation, wear personal protective equipment such as protective clothing,
insulated shoes, goggles, safety helmets, and insulated gloves.
General Requirements
⚫ Do not stop protective devices. Pay attention to the warnings, cautions, and related
precautionary measures in this document and on the equipment.
⚫ If there is a likelihood of personal injury or equipment damage during operations,
immediately stop, report the case to the supervisor, and take feasible protective
measures.
⚫ Do not power on the equipment before it is installed or confirmed by professionals.
⚫ Do not touch the power supply equipment directly or with conducts such as damp
objects. Before touching any conductor surface or terminal, measure the voltage at
the contact point to ensure that there is no risk of electric shock.
⚫ Do not touch operating equipment because the enclosure is hot.
⚫ In the cases of a fire, immediately leave the building or the equipment area and
activate the fire alarm or call emergency services. Do not enter the affected building
or equipment area under any circumstances.
To Next Page
Loading...
