Shanghai Pytes Energy Co., Ltd
Step 1 Connect the PE cable to each battery Ground point, and tight the screw, as
shown below:
Step 2 Connect the other terminal to a reliable external ground point.
Connecting Battery Power Cable
In this chapter, we are using Victron Fuse holder, 150A Fuse, 250A Busbar as example, installer can choose proper device
according to local regulation.
Step 1 Connecting Fuse and Fuse holder.
⚫ Install Fuse holders for Positive cable and Negative cable on a reliable surface.
⚫ Connect Battery positive power cable with fuse and install on Fuse holder, tighten
the screw. It is recommended to use 150A fuse for each battery.
⚫ Connect Battery negative power cable with fuse and install on Fuse holder, tighten
the screw. It is recommended to use 150A fuse for each battery.
⚫ Repeat for other batteries.
To Next Page
Loading...
