Qel M-CONTROLLER II - 5 Controller Supports Devices; Input Devices; Output Devices

M-Controller II System Operation Manual - 14 -
84350-201-001 Rev C
5 M-Controller supports Devices
5.1 Input Devices
 32x Digital Sensors: Q5, Q6, Q8, M5, QTS-8000, QIRF, M-AI …
 8 channels Analog Sensors: QTS-6000, QTS1710 …
 2 channels Switch Input: Q-Switch or any dry contact
5.2 Output Devices
 M-Relay: Each M-Relay takes 8 relay addresses.
Relay numbering from the standpoint of the M-Controller is numbered
consecutively with numbers 1, 2 and 3 being the M-Controller internal relays and
numbers 4 through 99 the relays in the remote modules.
For example, the 8 relays in the M-Relay #0 will be named Relay4 to Relay11 in
M-Controller. Details see M-Relay Manual (84350-104-000)
M-Controller also names M-Relay with its address and channel, like “MR-XX-
YY”, where XX is the M-Relay address and YY is Channel 1 to 8. MR-00-01
indicates Relay 1 in M-Relay module #0.
 QRP: Each QRP takes 8 relay addresses too.
QRP is a remote display panel for M-Controller to display relay status and gas
concentration. It contains 4x removable relays and 3x 24VDC transistor output for
local alarms, fans, buzzer, strobe and horn. So, it only uses 7 relays addresses for
the 4 relays and 3 transistor outputs, the 8th relay address is empty.
For example, the Relay1 to Relay4 in the QRP #1 will be named Relay12 to
Relay15 in M-Controller, buzzer, strobe and horn in the QRP #1 will be named
Relay 16 to Relay 18, Relay 19 is empty. Details see QRP Manual (86050-001-
000)
M-Controller also names QRP with its address and channel, like “QRP-XX-YY”,
where XX is the QRP address and YY is the Relay 1 to 4 and its onboard buzzer,
strobe, and horn.
 M-Annunciator: Each M-Annunciator takes 8 relays address too
M-Annunciator provides an audible and visual indication of the status of the
system. It contains 3x LEDs to indicate a certain state of the controller. It only use
3 relays addresses for the 3 Warning, Alarm and Failure LEDs, the 4-8 relay
address is empty.
For example, the 3xLEDs in the M-Annunciator #2 will be named Relay20 to
Relay22 in M-Controller, Relay 23-27 are empty. Details see M-Annunciator
Manual (84750-101-000)