M-Controller II System Operation Manual - 30 -
84350-201-001 Rev C
8.1 M-View Installation
The M-View software has been designed as an easy-to-use configuration software
package, greatly reducing the lengthy task of entering individual keystrokes through the
keypad to quick configuration with the mouse. M-View allows for both programming and
audit control, as you may download, upload and save programs to disk. Professional
Version M-View also can Real Time Monitoring the current readings and statuses of M-
Controller, Data logging these readings and statuses and Historical Data Review.
Standard Version M-View is limited to the three functions but have 5 minutes Real Time
Monitoring function. The Standard Version M-View is free for all M-Controller users.
Minimum system requirements:
Operating System: Windows XP or better
Ram: 16 Megabyte of RAM
Hard drive: 50 Megabytes free
Speed: Any
Mouse: Preferred (can navigate by ‘tab’)
USB Port: USB A
To install M-View, insert the CD or USB Flash drive into the computer and run
Setup.exe. Follow the instructions on the screen.
If your computer installed previous version M-View, the setup program will remove
it first, then run Setup.exe again to install the latest version M-View.
NOTE:
WHEN PROGRAMMING THE M-CONTROLLER WITH A LAPTOP THROUGH USB
PORT ENSURE THAT THE LAPTOP IS NOT CONNECTED TO ANY POWER
SOURCE. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT WITH
DAMAGES TO THE CONTROLLER AND OTHER DEVICES CONNECTED TO IT.
To Next Page
Loading...